Viconics VT8000 Series Device Replacement Guide Uživatelský manuál stáhnout pdf (Strana 4)

VT8000 Controller Replacement Guide

028-0454-00 www.viconics.com | sales@viconics.com November 2014

Object Name Default Conﬁgurations

Current Conﬁgurations

before Replacement

Units (Temperature Scale) °C

Low Backlight 60%

Night Backlight 5%

RH display Enabled

The below parameters are not accessible through the Setup menu in the VT8300/VT8350. However, they can be modiﬁed via the front

end Room Controllers once the device is online.

Object Name Default Conﬁgurations Current Conﬁgurations before

Replacement

More BACnet/ZigBee objects

System Mode Sequence#1 (Heat only)

Fan Mode N/A

Short Screen Message (BACnet only) Off

Long Screen Message (BACnet only) Off

Display Long Screen Message No

Heating Demand Limit N/A

Cooling Demand Limit N/A

No Activity Sleep Mode Disabled

Depending on Firmware version of MPM, some properties (such as Display Long Screen Message) do not show up in the Objects list.

NOTE

This document has one procedure to remove a Room Controller on a ZigBee Network and one procedure to remove a Room Controller

on a BACnet Network. Make sure to use the correct procedure.

1 2 3 4 5 6 7

Žádné komentáře

Viconics VT8000 Series Device Replacement Guide Uživatelský manuál Strana 4